Innotek UltraSmart IUT-300E Mode D'emploi page 7

IUT-300E Manual 1/19/05
collar's internal diagnostics will check that the battery charge is
full and that all circuits are working correctly. Do not touch the
metal contacts during this test. ReadyTest
confidence that your collar is working and ready to go.
If Continuous Red – If the ReadyTest
tone and the LED will glow solid red for 20 seconds. Replace in the
charger for 5 seconds, then remove. Do not touch the metal
contacts. If the unit continues to fail, call your authorized Innotek
Service Center.
PerfectFit ™ Test for Skin Contact
When turning the collar ON, hold the Tone
seconds. The collar will go into PerfectFit
emit a click tone as the contacts touch your dog's skin. A proper
fit will be acknowledged with 5 consecutive click tones.
To skip the PerfectFit ™ test, just turn the collar ON by pressing the
t
Tone button less than 3 seconds. The collar will function
normally, bypassing the PerfectFit
Fitting the Collar
The collar strap should fit snugly towards
the top of your dog's neck with the collar
unit on the bottom of the neck. Check
that the INNOTEK ® logo is right side up.
You should be able to get one finger
between the collar strap and your dog's
neck. The contacts must make contact with the dog's skin for
proper operation. A little hair thinning may be required. Do not
shave your dog's neck.
Occasionally, check the tightness of the contacts to ensure they
will not be lost from the collar. Lost components are not covered
under your warranty.
Trim excess strap along the diagonal score marks. You'll want to
leave about 2 inches of excess strap. Note if your dog is young and
you expect him/her to grow, you'll want to leave extra strap to
adjust the collar fastening. Replacement straps are available.
7:15 PM Page 8
™ gives you added
™ self-test fails, the unit will
t
button for 3
™ mode. The collar will
™ test.
About 2 dog systems
If you purchased the IUT-300E system, and wish to add another
collar, accessory collars are available where you bought your
training system, or call your authorized Innotek Service Center.
Take the first collar, set your remote to
p
Tone button. Set it down, then take the second collar, set your
d
remote to , and turn it on. The remote will send a signal to
whichever collar appears in the remote display window. To switch
C
between collars, press the
Testing the Collar
You may wish to test the collar from time to time. To test:
• Hold the test light provided across the collar's metal contacts
• Press the stimulation button on the remote
• The test light will illuminate
• The intensity of the test light will increase as the level
increases
Replacement Batteries:
Your remote uses a 9-volt alkaline battery, or a rechargeable nickel
metal hydride (NiMH) battery.These are commonly available where
you bought your training system, or where batteries are sold.
Operating Range
Your remote communicates with your pet's collar via a radio
signal. A variety of factors may affect your system's operating
range, positively or negatively. These include weather, terrain,
vegetation, proximity to metal structures including buildings and
fences, and other factors. Some things like outside radio
interference and emissions will diminish your range.
For best results at maximum distances, keep your fingers away
from the antenna. Hold the transmitter upright, above eye-level,
and away from your body.
6
D
, and turn it on with the
button.