Factory Default Settings; Technical Support - Numatics ControlNet G2-2 Serie Manuel

12) Factory Default Settings

Unless otherwise requested, all standard G2-2 Series ControlNet manifolds ship with specific factory default
settings. Below is a list of the factory default settings:
Input Module Power Jumper
Output Module Power Jumper
Valve Side Output Bytes
Discrete I/O Side - I/O Bytes

13) Technical Support

For technical support, contact your local Numatics distributor. If further information is required,
please call Numatics Inc. at (248) 887-4111 and ask for Technical Support.
Issues relating to network set-up, PLC programming, sequencing, software related functions, etc...
should be handled with the appropriate product vendor.
Information on device files, technical manuals, local distributors, and other Numatics, Inc. products
and support issues can be found on the Numatics, Inc's WEB site at
For general help or more information regarding the fieldbus you may access the ControlNet International
homepage found at
G2-2 Series ControlNet Quick Start Manual
Description
Node Address
Baud Rate
www.controlnet.org
3835052 TDG22CNQS4-0
Subject to change without notice
www.numatics.com/fieldbus
Default Settings
5 Mbit/sec
(Input sensor power supplied by
+24VDC Node and Inputs pin on the Aux. power connector)
(Output module power supplied by
+24VDC Valves and Outputs pin on the Aux. power connector)
4 Bytes (32 Allocated Valve Coil Outputs)
Self-Configuring
based on the I/O modules installed.
1/07
0
PU
SP
www.numatics.com
Page 11