Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Checking for gas leaks
•
Leak testing of the appliance shall be conducted according to the manufacturer's
instructions. Do not use a flame to check for gas leaks. Use a brush to spread a soapy
water mixture around the area you are checking. If there is a gas leak, you will see small
bubbles in the soapy water mixture at the leak point.
ELECTRICAL AND gROUNDINg SAFETY
WARNING To reduce the risk of fire, electric shock, personal injuries, and/or death,
obey the following precautions.
•
Plug into a grounded 3-prong outlet.
•
Do not remove the ground prong.
•
Do not use an adapter or an extension cord.
•
Do not use a damaged power plug, power cord,
or loose power outlet.
•
Do not modify the power plug, power cord, or
power outlet in any way.
•
Do not put a fuse in a neutral or ground circuit.
•
Use a dedicated 120-volt, 60-Hz, 20-amp, AC, fused electrical circuit for this range. A
time-delay fuse or circuit breaker is recommended. Do not plug more than one appliance
into this circuit.
•
Do not connect the ground wire to plastic plumbing lines, gas lines, or hot water pipes.
•
This range must be Earth grounded. In the event of a malfunction or breakdown,
grounding will reduce the risk of electrical shock by providing a path for the electric
current. This range is equipped with a cord having a grounding plug. The plug must be
firmly plugged into an outlet that is properly installed and grounded in accordance with
the local codes and ordinances. If you are unsure whether your electrical outlet is properly
grounded, have it checked by a licensed electrician.
•
The range is supplied with a 3-pronged grounded plug. This cord must be plugged into
a mating, grounded 3-prong outlet that meets all local codes and ordinances. If codes
permit the use of a separate ground wire, we recommend that a qualified electrician
determine the proper path for this ground wire.
•
Electrical service to the range must conform to local codes. Barring local codes, it should
meet the latest ANSI/NFPA No. 70 – Latest Revision (for the U.S.) or the Canadian
Electrical Code CSA C22.1 – Latest Revisions.
•
It is the personal responsibility of the range owner to provide the correct electrical service
for this range.
English - 10
Publicité
Table des Matières
