Maintenance And Cleaning; What To Do, If; Protecting The Environment - AEG SYSTEM PRO Mode D'emploi

Maintenance and cleaning

GB
For maintenance or cleaning, switch off the appliance and unplug it from the mains.
As required, wipe the housing and the dustbag chamber with a damp cloth and then dry. Do not use
any scourers or any solvents. Occasionally vacuum the floor nozzle and the brush-heads with the
crevice nozzle.

What to do, if...

... it is difficult to push the nozzle:
Reduce suction power (depending on the type of carpet). This will not conspicuously reduce the
cleaning efficiency.
...the motor thermal cut-out has tripped: e. g. as the result of overloading the motor if the dust-
bag is full or if an accessory is blocked.
Switch off the appliance, unplug from the mains, and leave the motor to cool down. Check dustbag,
suction tube and suction hose; remove any blockage. The appliance can be switched on again after
approximately 30 minutes.
... the fuse has blown: The fuse can be blown if other electric appliances with a high power con-
sumption are used at the same time and on the same circuit as the vacuum cleaner.
If this is the case, set the suction power regulator to the lowest setting before switching on and only
select a higher suction level after switching on.
... the cable does not retract fully:
The cable is caught up on the cable drum.
Pull the cable out again a little and press button A again.
....the dust chamber lid will not close:
Check that the dustbag has been inserted.
If it has, check that the dustbag has clicked into position.

Protecting the environment

Appliance packaging: We recommend keeping the packaging for the duration of the guarantee so
that the appliance can be transported safely.
Recycling the appliance at the end of its life: The plastic components all carry a material identi-
fication marking so that, like the other materials, they can be recycled at the end of the life of the
appliance.
22
All manuals and user guides at all-guides.com