Uline H-196 Mode D'emploi page 2

SETTING UP CANVAS BAG
1. Roll canvas bag down from the top until four
grommets are exposed (about midway down the
canvas bag). (See Figure 3)
2. Locate two steel rods with tail ends.
3. Insert one tail end through grommet at corner of
canvas bag. Do not try to fit grommet into the loop.
(See Figure 4)
Figure 4
4. Insert the other tail end through grommet on the
opposite corner of canvas bag.
5. Repeat step three and four with the second rod
creating an "X" across the bag.
6. Locate U-bolt and remove the two nuts and plate
from the bolt.
7. Place U-bolt over the center of rods "X" formation.
8. Re-insert plate, then the two nuts on the U-bolt.
Tighten nuts with pliers. (See Figure 5)
PAGE 2 OF 6
INSTRUCTIONS CONTINUED
Figure 3
Grommet
Plate
Nuts
Figure 5
1-800-295-5510
uline.com
9. Carefully roll up the bag to ensure rods stay in place.
10. Locate four PVC pipes with eye ends.
11. Slide pipe into hem at the top of canvas bag.
(See Figure 6)
12. Repeat step 11 with the three other PVC pipes to
form a square.
13. Locate four chains attached to rope.
14. Remove nut from the bolt at the end of the four chains.
15. Align the eye end holes of adjacent PVC pipes.
(See Figure 7)
16. Insert bolt through the aligned eye-end holes of PVC
pipes. (See Figure 7)
17. Replace the nut on the bolt. Tighten using pliers.
(See Figure 7)
18. Repeat steps 15-17 with the other three sides to form
a square.
19. Thread rope through both pulleys.
20. Raise bag to desired height and tie off rope.
Figure 6
Figure 7
0521 IH-196