hestan KWD 30 Mode D'emploi page 14

CLEANING AND MAINTENANCE
(CONT.)
CLEANING
The only recommended maintenance for the Warming Drawer is cleaning.
EN
Before you begin cleaning, turn the appliance OFF and disconnect the appliance from the outlet.
Allow the appliance to cool before cleaning it.
NOTICE
Do not use harsh detergents or abrasive products and/or scrubbing pads and sponges and sharp
objects as they can stain and damage the appearance of the appliance.
Never use a vacuum cleaner on the internal parts of the appliance.
FRONT SURFACE AND CONTROL PANEL
The use of a moist cloth is often sufficient when cleaning the appliance. If needed, add a few
drops of detergent in the water. Dry the appliance with a dry cloth. The steel front of the
appliance can be cleaned with products specifically designed for steel.
Such products prevent the formation of dirt on the surface of the drawer. Apply a minimal
amount of the product on a soft and apply it to the surface of the appliance.
INSIDE SPACE
To clean the inside space use a moist cloth. In the event the appliance requires further cleaning
add drops of detergent to the water. Dry the surface with a dry cloth. Make sure to avoid water
draining into the ventilation holes. Only use the appliance after the drawer is completely dry.
REPLACING A WARMING DRAWER LIGHT BULB
The Warming Drawer is equipped with two halogen lights, located on the right side of the unit.
ELECTRICAL SHOCK HAZARD - Make sure the power has been shut off to the Warming
Drawer. The light socket is energized when the door is open. Failure to shut off the power when
replacing a light bulb could result in electric shock or burns.
Make sure the glass lens is cool to the touch. Use care when handling the lens, it is fragile and
can break if dropped.
Use only 20 watt, 12 Volt, halogen "Bi-Pin" bulbs suitable for appliance use. This type of bulb
may be available at hardware stores & home centers, or specialty lighting stores. Call Hestan
Customer Care for more information.
12
©2018 Hestan Commercial Corporation