Twin-Star 18EF003GAA Manuel D'instruction page 7

NOTE: We do not supply new lightbulbs for these
units. New lightbulbs can be purcahsed at your local
home center, hardware store or grocery store.
WARNING: Do not exceed 40 Watts
per bulb. Use of higher rated bulbs
may result in a fire, causing property
damage or personal injury.
REPLACING THE DOWNLIGHT BULBS
Models 28EF003GRA and 33EF003GRA
ONLY
This fireplace uses (1) clear 120V, 4 Watt E12
socket light bulb (open, small base, night light
type). Tools required (1) Phillips head screw-
driver. For convenience, if a bulb burns out, it is a
good idea to replace all bulbs at the same time.
1.) Turn the master power switch off, then
UNPLUG the power cord from the wall outlet.
2.) If fireplace has been operating, let the unit
cool at least 2 hours.
3.) Open control panel door, locate and remove
the 3 screws in/between the door and main
body of insert (Figure 3).
4.) Close the control panel door, and pull glass
frame and glass toward you. Carefully tilt
glass and frame forward a couple of inches
then pull complete glass assembly up and away
from unit(Figure 4).
5.) Locate downlight on the inside ceiling of the
firebox(Figure 7). Unscrew the lightbulb and
replace with (1) one clear 120V, 4 watt, E12
socket light bulb.
6.) Follow steps 1 through 4 in reverse order to
reinstall glass and frame into your insert.
All manuals and user guides at all-guides.com
E-6
Figure 7
TO ACCESS
DOWNLIGHT
REACH UNDER HERE
EMBERBED LIGHT BULB
Figure 8
LIGHT BULB HOLDING SPRING
PULL
PULL