Installation Instructions; Parts List - Twin-Star 18EF003GAA Manuel D'instruction

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Position your completed Wood Mantel close to its

final location. Make sure you can access the back of

the Fireplace, as your Electric Fireplace Insert will be

installed from the back.

Using a Phillips head screwdriver, remove the screws

and the metal mounting brackets attached on either

side of the fireplaces center opening. Next unpack

the Electric Fireplace Insert carefully. Position insert

behind fireplace with front facing the wood mantel.

With the help of an adult assistant, lift the Insert and

gently slide it into the opening in the mantel until the

flange is flush against the inside of the fireplace. Make

sure insert is centered left and right in the opening. Be

careful when placing insert and adjusting, bottom of

insert could scratch the finish of the wood base/hearth

of your fireplace. Re-attach the mounting brackets

with the Phillips head screwdriver, and supplied

screws. DO NOT OVER TIGHTEN.

With the help of an assistant, carefully lift completed

unit and place it with the front facing out in the final

Emberbed

Heater/Blower Assembly

Thermostat Switch

Knob for Brightness Control

Knob for Heater Temperature control

Downlight On/Off Switch

Heater On/Off Switch - Black

Main Power Switch - Red Toggle

Heater On/Off Switch - Red Toggle

Brightness Dimmer Switch

E-12 Light Bulb Sockets

Circuit Board - On/Off Remote

Front Projection Screen

Flame Generator Drive Motor

Flame Generator/Spinner

Decorative Brick Panels

Remote Control - 3 Function

All manuals and user guides at all-guides.com