Electrolux EUCP2245AW Notice D'utilisation page 12

12 www.electrolux.com
Problem
A or
shown instead of numbers
on the Temperature Dis‐
play.
The lamp does not work.
The compressor operates
continually.
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the "FastFreeze",
or after changing the tem‐
perature.
Temperature cannot be
set.
dEMo appears on the dis‐
play.
All manuals and user guides at all-guides.com
Possible cause
Temperature sensor
symbol is
problem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The "FastFreeze" is
switched on.
The door is not closed
correctly or the gasket is
deformed/dirty.
This is normal, no error
has occurred.
The "FastFreeze func‐
tion" is switched on.
The appliance is in dem‐
onstration mode.
Solution
Contact the nearest Author‐
ised Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
Close and open the door.
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation".
Wait few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze func‐
tion".
Refer to "Closing the door".
The compressor starts after
a period of time.
Switch off "FastFreeze func‐
tion" manually, or wait until
the resets automatically to
set the temperature. Refer to
"FastFreeze function".
Keep the OK pressed for ap‐
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.