Publicité
Les langues disponibles
Les langues disponibles
Tetra
miniMAX
®
Layout Modules
Before you begin, clean surfaces and
1
remove all debris from the inside of
the channel letter.Clean the surfaces
with a 50:50 mixture of isopropyl
alcohol (IPA) and water and let dry.
Use rivets, screws, or electrical
4
grade RTV silicone to secure
at least every fifth LED module
within the channel letter. Use #6
(M3) pan headed metal screws,
1/8-inch (3.2 mm) rivets, or
electrical grade RTV silicone.
Electrical Connections
NOTE: Do not use connectors pre-filled with silicone grease/mineral base protective grease or use silicone grease to seal connections.
Red stripe (+)
Connect LED strips using in-line (IDC) connectors or
1
twist-on wire connectors.
NOTE: Seal all connections in wet locations with
electrical grade RTV silicone.
Measure and cut Tetra LED strip
2
to the appropriate length for
each letter. Cuts can be made
between any of the modules.
Drill a 1/4-inch (6.4 mm) hole
5
near the LED strip and grommet
the hole for supply wire access.
NOTE: For halo-lit applications LED modules should be mounted on UL recognized
clear acrylic or polycarbonate. The light output from the LED system should be
directed back into the sign enclosure. This will allow for uniform backlighting of the
sign and will provide simple mounting.
Seal all connections in wet locations
with electrical grade RTV silicone
White (-)
Cap wires
Must cap all exposed wires with appropriate wire
2
connectors and seal with electrical grade RTV silicone.
Optional: Cut wires flush to the module and seal with
electrical grade RTV silicone.
3
Installation Guide
Do not
press lens
Remove tape backing and stick LED
3
modules into place. When using tape
apply approximately 15 psi pressure
on the module (avoid the lens dome
surface) for 5 seconds, full bonding
strength after 24 hours. Continue until
you have reached the end of the strip.
Remove all the debris from the
6
inside of the channel letter and
replace the sign face.
Optional: Cut wires flush
Publicité
