Daintree GE Current Tetra miniMAX GEMM2471-W1 Guide D'installation page 2

Tetra miniMAX
®
Prepare Electrical Wiring
Electrical Requirements
• Acceptable for use in dry, damp and wet locations.
• The grounding and bonding of the LED Driver shall be
done in accordance with National Electric Code (NEC)
Article 600.
• Follow all National Electric Codes (NEC) and local codes.
• These products are only suitable for connection to a
circuit from a Class 2 power source.
• These products have not been evaluated for use when
connected to a power source that does not comply with
Class 2 voltage and energy limited supplies.
Components
1
2
5
T Measure Point
6
C
Components - Tetra
Tetra MiniMAX is also compatible with the following Tetra SNAP Rail components.See
https://www.gecurrent.com/eu-en/outdoor-lighting/led-signage-lighting for further details and install instructions.
1
2
FOR UL ONLY
4
3
7
SNAP Accessories (optional)
®
3 4 5
6
7
Save These Instructions
Use only in the manner intended by the
manufacturer. If you have any questions, contact the
manufacturer.
RETROFIT SIGN CONVERSION LED KIT FOR USE ONLY
IN ACCORDANCE WITH KIT INSTRUCTIONS.
KIT IS COMPLETE ONLY WHEN ALL PARTS REQUIRED
BY THE INSTRUCTIONS ARE PRESENT.
TROUSSE DE CONVERSION À DEL POUR LA
MODERNISATION DES ENSEIGNES
À UTILISER CONFORMÉMENT AU GUIDE D'INSTALLATION.
1 UL approved 18 AWG (0.82 mm
UL approved 22-14 AWG (0.33-2.08 mm
2
22-18 AWG (0.33-0.82 mm
equivalent
3 #6 (M3) screws, 1/8 inch (3.2 mm) rivets, or electrical grade RTV
silicone or equivalent
4
Weather box GEXNWB2 (optional)
5 Tetra ® 24 Volt Power Supply
Tetra ® miniMAX LED modules
6
7
Electrical grade RTV silicone:
• Momentive RTV 6700 Series Silicone Rubber Adhesive Sealant
• Momentive White Blanc RTV 162 Silicone Rubber Adhesive
Sealant-Electrical Grade
• Dow Corning 3140 - Non-Corrosive Flowable (clear)
• Dow Corning 3145 - Non-Corrosive Nonflowable (clear or gray)
• Dow Corning RTV 748 Non-Corrosive Sealant-White
Tetra SNAP Rail (GEDSRL08-3)
1
Tetra Snap SS Metal Clip (GESSMC-3)
2
Tetra SNAP Frame Endcap (GEDSFE-3)
3
Tetra SNAP Socket Endcap (GEDSSE-3)
4
Tetra SNAP Dual Rail Socket Cap (GESSDR-3)
5
Tetra SNAP T-connector (GEDSTC-3)
6
7 Tetra SNAP Interconnector (GEDSIC-3)
2
Installation Guide
) supply wire or approved equivalent
2
) wire connectors or
2
) in-line/IDC connectors or approved
2