GE XPIO13BCBT Manuel D'utilisation page 12

Side Tank Accessory
6. Continued.
Side tank clip
7. Remove Opal Side Tank's reservoir from i ts base.
8. U nscrew Opal Side Tank's cap from the reservoir. F ill the clear reservoir with water.
9. R eplace Opal Side Tank's cap. Ensure the cap is clean when installing.
10. C arefully flip over Opal Side Tank's reservoir and place in the base. Water should start flowing into the Opal
Nugget Ice Maker and bubbles in the Opal Side Tank will appear periodically during the time water is flowing to the
ice maker.
NOTE: If water does not appear to flow into the ice maker, please check for the following:
- T here may be bubbles in tube (B) connecting the Side Tank to the Opal.
- Tube (B) is not lying flat.
If either of the above issues are present, adjust tube (B) to allow the water to flow.
11. Fill Opal Nugget Ice Maker's reservoir (if desired).
12. Plug in Opal Nugget Ice Maker, and begin making ice.
12
Side tank
clip area
Bottom view
Side tank clip
Bottom view
49-1000464 Rev. 1