Elba DREAMline 126 EX 884 Mode D'emploi page 11

LIGHTING GAS BURNERS FITTED
To ignite the burner, the following
instructions are to be followed:
1) Press in the corresponding knob and
turn counter-clockwise (fig. 2.2 to the
full flame position marked by the
symbol (fig. 2.1) and hold the knob in
until the flame has been lit.
In the case of a mains failure light the
burner with a match or lighted taper.
2) Wait for about ten seconds after the
gas burner has been lit before letting
go of the knob (valve activation
delay).
3) Adjust the gas valve to the desired
position.
If the burner flame should go out for
some reason, the safety valve will auto-
matically stop the gas flow.
To re-light the burner, return the knob to
the closed position, wait for at least
1 minute and then repeat the lighting
procedure.
If your local gas supply makes it difficult
to light the burner with the knob set to
maximum, set the knob to minimum and
repeat the operation.
Fig. 2.2
All manuals and user guides at all-guides.com
CHOICE OF THE BURNER
On the control panel, near every knob,
there is a diagram that indicates which
burner is controlled by that knob.
The suitable burner must be chosen
according to the diameter and the capac-
ity used.
As an indication, the burners and the
pots must be used in the following way:
DIAMETERS OF PANS WHICH MAY BE USED
ON THE HOBS
BURNERS MINIMUM
Auxiliary 12 cm
Semirapid 16 cm
Rapid 24 cm
Rapid
( central rear)
Triple-ring
Fish-burner from 12x30 up to 18x40 cm
Wok max 36 cm
do not use pans with concave or convex bases
It is important that the diameter of the
pot be suitable to the potentiality of the
burner so as not to compromise the high
output of the burners and therefore
energy waste.
A small pot on a large burner does not
give you a boiling point in a shorten
amount of time since the capacity of
heat absorption of a liquid mass
depends on the volume and the surface
of the pot.
Fig. 2.3a
MAX.
14 cm
24 cm
26 cm
24 - 24 cm
26 cm 28 cm
11