Jenn-Air JGC7530B Serie Mode D'emploi page 5

36" (91.4 cm) Models
A B
F
A. Left rear burner
B. Center rear burner
C. Right rear burner
6. Remove all burner caps and burner bases.
A. Gas tube opening
B. Burner cap slot (4)
C. Burner cap
D. Burner base
7. To Convert Burners:
Insert 7.0 mm nut driver down onto the gas orifice spud (C)
and remove by turning it counterclockwise and lifting out.
Set gas orifice spud aside.
Replace with correct LP gas orifice spud. See the LP Gas
Orifice Spud Chart.
B
A
C
A. Igniter electrode
B. Orifice holder
C. Orifice spud
C
E D
D. Right front burner
E. Center front burner
F. Left front burner
A
B
C
D
E
F
G
H
E. Burner base tab (4)
F. Burner base notch
G. Orifice holder
H. Igniter electrode
8. Place Natural gas orifice spuds in plastic parts bag for future
use and keep with package containing literature.
9. Replace burner bases and burner caps.
IMPORTANT: Be sure that the electrode aligns with the notch
in the burner base. The igniter electrode is ceramic and could
break during installation of the burner base.
A
A. Burner cap
B. Electrode
C. Burner base
10. Open shutoff valve in the gas supply line. The valve is open
when the handle is parallel to the gas pipe.
11. Once you have completed converting all of the cooktop
burners, test the cooktop for leaks by brushing on an
approved noncorrosive leak-detection solution. If bubbles
appear, a leak is indicated. Correct any leaks found.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
12. Plug in cooktop or reconnect power.
13. Adjust valve according to "Flame Height Adjustment" section.
B
C
5