Black & Decker Powerfile PF260 Mode D'emploi page 7

90520629 PF260 manual 5/16/07
NOTE: Only those dust masks suitable for working with lead paint dust and fumes
should be used. Ordinary painting masks do not offer this protection. See your local
hardware dealer for the proper (NIOSH approved) mask.
• NO EATING, DRINKING or SMOKING should be done in the work area to prevent
ingesting contaminated paint particles. Workers should wash and clean up BEFORE
eating, drinking or smoking. Articles of food, drink, or smoking should not be left in the
work area where dust would settle on them.
ENVIRONMENTAL SAFETY
• Paint should be removed in such a manner as to minimize the amount of dust
generated.
• Areas where paint removal is occurring should be sealed with plastic sheeting of 4
mils thickness.
• Sanding should be done in a manner to reduce tracking of paint dust outside the work
area.
CLEANING AND DISPOSAL
• All surfaces in the work area should be vacuumed and thoroughly cleaned daily for the
duration of the sanding project. Vacuum filter bags should be changed frequently.
• Plastic drop cloths should be gathered up and disposed of along with any dust chips or
other removal debris. They should be placed in sealed refuse receptacles and
disposed of through regular trash pick-up procedures. During clean up, children and
pregnant women should be kept away from the immediate work area.
• All toys, washable furniture and utensils used by children should be washed
thoroughly before being used again.
ADJUSTMENTS
WARNING: To prevent accidental operation, turn off and unplug tool before
performing the following operations. Failure to do this could result in serious
personal injury.
ATTACHING AND REMOVING SANDING ARMS (FIG. B)
Attaching
• Loosen and remove the belt tracking knob (6).
• Check that the spring (10) is located in its mounting hole.
• Position the arm (4) as shown.
• Thread in belt tracking knob (6) and tighten it until the arm is aligned with the tool.
Removing
• Remove the sanding belt (if present) as described below.
• Loosen and remove the belt tracking knob (6).
• Remove the arm.
ATTACHING AND REMOVING SANDING BELTS (FIG. C)
Attaching
• Move the belt tensioning lever (5) to the front position (A).
• Make sure that the arrows on the inside of the sanding belt face the same direction as
the arrows (13) on the housing.
• Place the sanding belt (11) over the front pulley (12) and the rear pulley (14), sliding it
through the slot in the housing.
• Move the belt tensioning lever (5) to the rear position (B).
• Adjust the belt tracking as described below.
Removing
• Move the belt tensioning lever (5) to the front position (A).
• Slide the sanding belt (11) off the pulleys.
ADJUSTING THE SANDING BELT TRACKING (FIG. D)
• Switch the tool on by pressing the on/off switch (1).
2:41 PM Page 7
7