Power Supply - Deltran Battery Tender Power Plus Manuel

5) 1.25A CHARGE/MAINTENANCE: The alligator clips must be
connected to the battery to start the charge cycle. When the clips
are connected, the battery level indicator will illuminate to show the
state of charge. To start the charge cycle, press the charge select
button or wait four (4) seconds. The charge LED will turn on solid
and the battery level lights will begin to illuminate from left to right
indicating a charge is in progress. All the battery level lights will be
on solid when the battery is fully charged and in maintenance
mode.
6) 20A BOOST: To start the boost cycle press the function select
button until the 20A Boost led is illuminated. Connect the alligator
clips to the battery and the LED's in the battery level indicator will
illuminate. Then press the boost select button and the LED will turn
solid to begin the boost cycle. The five (5) left battery level lights
will begin to illuminate from left to right until they are all solid and
the battery has reached 14 volts. The boost cycle will then shut off.
7
7) 75A ENGINE START: To start the engine start cycle, press the
function select button until the engine start LED is blinking.
Connect the alligator clips to the battery to begin the engine start
cycle. In order to begin the engine start mode, the battery voltage
needs to be above 10.5 volts. If this is not the case, the charger will
enter Boost Mode (All battery LEDs blink).
Once the battery has reached 10.5 volts, an engine start can be
performed. At this point, the Battery LEDs will light up in sequence
from left to right.
8) POWER SUPPLY: To start the Power Supply mode, press the
function select button until the Power Supply LED is illuminated.
Connect the alligator clips to the battery. Then press the power
supply button, the power supply LED will then turn solid green
while also turning the power supply on.
9) WiFi: When AC power is applied to the charger the WiFi will
automatically turn itself on. If you wish to turn the WiFi off, hold the
battery select button down for ten (10) seconds.
The WARNING/ERROR LED will blink to indicate the WiFi is off.
To turn the WiFi back on, simply press the select button down for
ten (10) seconds.
8