Electrolux FI22/12NDV Notice D'utilisation page 14

14 www.electrolux.com
Problem
The compressor does not
start immediately after
pressing the FastFreeze,
or after changing the tem‐
perature.
The compressor does not
start immediately after
pressing the Shopping‐
Mode, or after changing
the temperature.
Water flows inside the re‐
frigerator.
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
All manuals and user guides at all-guides.com
Possible cause
The door is not closed
correctly.
The FastFreeze function
is switched on.
The ShoppingMode func‐
tion is switched on.
This is normal, no error
has occurred.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze or Shop‐
pingMode function is
switched on.
The appliance is in dem‐
onstration mode.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
Solution
Refer to "Closing the door".
Refer to "FastFreeze func‐
tion".
Refer to "ShoppingMode
function".
The compressor starts after
a period of time.
The compressor starts after
a period of time.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or ShoppingMode
function".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".