Symbols Used; Intended Use - Truma VarioHeat Instructions De Montage

Truma VarioHeat
Table of contents

Symbols used ...................................................................... 11

Intended use ........................................................................ 11

Safety instructions .......................................................... 12
Operation while driving ....................................................... 12
Regulations ......................................................................... 12
Installation instructions
Installation instructions .................................................. 12
Scope of delivery ................................................................ 12
Vehicles ............................................................................... 12
Water supply ....................................................................... 13
Selecting a location ......................................................... 13
Attaching the heater ....................................................... 13
Exhaust gas system ......................................................... 14
Permissible duct lengths ..................................................... 14
Installing the wall cowl ........................................................ 14
Connecting the exhaust double duct to the appliance ....... 14
Circulated air intake ........................................................ 15
Room temperature sensor installation ........................ 15
Selecting a location ............................................................. 15
Assembly ............................................................................. 15
Analogue control panel installation (optional) ........... 16
Selecting a location ............................................................. 16
Assembly ............................................................................ 16
Electrical connections ..................................................... 16
Connection diagram ............................................................ 16
12 V voltage supply ............................................................ 17
Battery connection .............................................................. 17
Room temperature sensor connection ............................... 17
Digital control panel connection ......................................... 17
Analogue control panel connection (optional) .................... 17
Window switch connection (optional) ................................ 17
Gas connection ................................................................. 18
Function check ................................................................. 18
Warnings ........................................................................... 18
Technical data Truma VarioHeat ................................... 18
Symbols used
The appliance must only be installed and repaired
by an expert.
Symbol indicates possible hazards.
Note containing information and tips.
Observe the ESD regulations! Electrostatic charging
can destroy the electronics. Ensure that potential com-
pensation is present before touching the electronics.
Wear protective gloves to prevent possible mechanical
injuries.
All manuals and user guides at all-guides.com
The operating instructions for this Truma appliance are
an important part of these installation instructions and
must be followed. The operating instructions are sup-
plied with the appliance as a separate document and
can also be downloaded at www.truma.com under the
heading Products.
Read the installation instructions, the operating instruc-
tions and the safety instructions carefully before com-
mencing the work, and then comply with them.
Intended use
Proper use
- The appliance is approved solely for installation and opera-
- The appliance may be used only to heat the vehicle's
- If the appliance is operated while the vehicle is in motion,
- If the appliance is being used for commercial purposes, the
Improper use
All other uses not listed under proper use are improper and
therefore prohibited. This applies for example to installation
and operation in:
- Motor buses of vehicle classes M2 and M3,
- Commercial vehicles of vehicle class N3,
- Boats and other water vessels,
- Hunting/forestry huts, weekend homes or awnings.
- Installation in trailers and vehicles used to transport hazard-
- Defective appliances must not be used.
- Appliances installed and utilised in contravention of the op-
tion in caravans and construction trailers of vehicle class O,
motor caravans of vehicle class M1, commercial vehicles
of vehicle classes N1 and N2 and mobile homes if the gas
system is installed in accordance with EN 1949. The nation-
al legislation and regulations for operating and testing gas
installations (e.g. DVGW Work Sheet G 607 in Germany)
must be observed.
interior.
facilities must be installed to prevent uncontrolled emission
of liquefied gas in the event of an accident (according to
UN-ECE regulation 122).
operator must ensure that special statutory and insurance
regulations of the respective destination country are ob-
served (e.g. DGUV regulations in Germany).
ous goods is prohibited
erating and installation instructions must not be used.
11