K2 Pumps UTT05001K Manuel Du Propriétaire page 4

INSTALLATION
This pump should be located on a solid, stable and level surface using:
1. Reinforced heavy-duty hose or plastic pipe for the Inlet Line.
2. 3/4" Standard garden hose for the Discharge Line.
Please note:
1. Do not hang the pump by the power cord, inlet pipe or hose. The pump must be placed on a stable surface. To
ensure that the pump works properly, keep the suction end of the hose or pipe free from debris and sludge.
2. If the water level is too low, any debris or sludge will dry out and stop the pump from starting. To ensure the
pump will start as required, check the pump regularly with start-up tests.
Areas of use
1. This pump is designed to pump water only.
2. This pump can be used for general purpose removal or transfer of clear water in household and farming
applications.
3. DO NOT use this pump for: continuous run applications, fountain or pond water features, emptying swimming
pools or spas, or with septic and sewage systems.
LOCATION
Pump (A) should be located within 15 ft. of the water source, and strainer (B) should be used at the end of the inlet line.
NOTE: Make sure the inlet hose is NOT coiled or kinked above or below water level. The inlet line may be galvanized
pipe, plastic pipe, or reinforced hose. Be sure there are no leaks in the inlet line, as this may reduce pump efficiency or
prevent priming. Inlet line should be the same diameter as the discharge line, or larger. DO NOT use regular garden
hose on the inlet line as it will collapse during pumping. Standard 3/4 in. garden hose may be used as a discharge line.
Keep the total length as short as possible for best performance.
4 For Professional Technical Support call 1-844-242-2475