Solve Setup Problems - Lexmark OptraImage 443 Guide Rapide

Solve setup problems

Problem
Ready status message not displayed
Control panel buttons not responding
Scan unit isn't working
Test document did not print
Unable to send or receive faxes.
Network scanning modes
(SCAN → PROFILE, SCAN → EMAIL,
and/or SCAN → FTP) don't appear in the
control panel
If you need more help
OptraImage Setup Guide
Solution
The control panel and the printer are not talking to each other, or the
printer or scanner may be turned off.
1 Turn printer off, and then back on.
2 Turn printer and scan unit off. Make sure all cables and cords are
connected, and then power up in the correct order. If the problem
continues, check the ends of the SCSI cables for bent pins. See "Turn
on scan unit and printer" on page 10.
Make sure the printer is turned on.
1 Make sure the scan unit is unlocked. See "Unlock the scan unit" on
page 5.
2 Turn printer and scan unit off. Make sure all cables and cords are
connected, and then power up in the correct order. For more
information, see "Turn on scan unit and printer" on page 10.
1 Verify each electrical outlet has power.
2 Make sure all cables and line cords are properly seated.
3 Restart the copy job.
1 Make sure the telephone fax line cable is properly connected to the fax
modem port on the print server and to the fax phone outlet.
2 Repeat the fax setup. See "Set up to send and receive faxes" on
page 16.
3 Refer to the online documentation on the OptraImage CD. Click View
Documentation, Use OptraImage, and then Solving fax problems.
Scan to network modes must be configured in order to show up in the
OptraImage control panel. See "Set up network scanning" on page 20 for
detailed instructions.
Launch the OptraImage CD, and then click Contact Lexmark
for a complete list of phone numbers and web sites.
25