Samsung DW80M9 Serie Guide D'installation page 13

3. Then, insert the ¾" 90 degree fi tting into the inlet valve (see Figure 4-B). Tighten until the ¾"
Fitting is tight and pointing towards the water hose channel in the base of the dishwasher
(about 4 o'clock). Do not over tighten.
4. Cut the strings securing the drain hose to the back of the dishwasher. Roll-out the hose.
Make sure there are no kinks and that the hose is not bent at any extreme angles that could
constrict the fl ow of water.
5. Remove the junction box cover located at the bottom front right of the dishwasher using a
screwdriver, and then Install the strain relief (Figure 4 - C). Make sure to keep the junction box
cover you removed. It is used in Step 10, Wiring Connections.
6. If the countertop is made of wood or a material that is not damaged by drilling, attach the
two (2) Installation brackets that were supplied with the dishwasher using the supplied
screws (Figure 4 - A). They will be used in Step 8, Securing the Dishwasher.
If the drain hose needs to go to the right of the
dishwasher, secure the hose in the hose fi xer mounted
on the base. There are three positions the hose fi xer can
be installed at. To move the hose fi xer, gently squeeze
the fi xer, the turn to the left.
Make sure to secure on the arrow-marked area.
<Figure 4>
B
DW9900M-00183B-01_EN.indd Sec3:13 DW9900M-00183B-01_EN.indd Sec3:13
90 º fi tting
A
C
Junction box
Strain relief
CAUTION
Do not overtighten the 90˚ Fitting.
(Below 280 lb·in (31.6 N·m))
Doing so may damage the water
inlet valve and cause a water leak.
installing the dishwasher _13
12/27/2016 6:22:49 PM 12/27/2016 6:22:49 PM