Zephyr Milano Island ZML-M90CG Guide D'utilisation, D'entretien Et D'installation page 17

ZEPHYRONLINE.COM
Mounting the Hood
FIG. G
11. Remove tape securing electronics mounting bracket to hood. Remove (2) screws from top of hood
body and set screws aside. Position electronics mounting brackets and secure to hood body using
the (2) previously removed screws (FIG. G).
12. Lift aluminum mesh filters from hood. Place canopy over blower housing located on top of hood
and secure it to hood body using (4) 3/16 x 1/4 pan-head machine screws through the filter
opening (FIG. H).
13. Lift hood body and align the (4) pre-installed mounting screws on top of blower housing (FIG. C5
on Page 14) with the (4) key holes on the bottom of the support frame. (FIG. I) Slide hood towards
the narrow end of key holes to lock in place. Hand tighten each of the (4) screws to secure hood
to bottom of support frame. Install (1) M4 x 12mm safety screw into bottom support frame to
further secure the hood. (FIG. I). Reinstall aluminum mesh filters.
Milano Island Use, Care, and Installation Guide
Installation Instructions
HOUSING
BLOWER
FIG. H
FIG. I
17