Before The First Use - Kalorik MFH 43974 Mode D'emploi

BEFORE THE FIRST USE

•
Before using the appliance for the first time, remove and peel off all
promotional and packaging materials.
•
Clean the milk pitcher under warm water before use.
OPERATION
•
Place the base of the unit on a flat, dry, and heat-resistant surface.
•
Remove the lid from the milk pitcher.
•
Place the desired disk (latte frothing/heating or cappuccino
frothing disk) inside the jug. To do this hold the disk from its shaft and
press inside the center of the jug until you hear a snap/click (see
image below).
•
There are four markings on the pitcher to indicate milk levels for 1 or
2 servings of cappuccinos or 1 or 2 servings of lattes depending on
the frother used. Pour fresh milk into the pitcher according to the
level required and then put back the lid onto the pitcher.
Note: Do not fill liquid above the markings as it runs a risk of overflow.
The maximum level of milk for the cappuccino beater is the '2
cappuccino cups' marking (approximately 270ml) whereas for the latte
beater, the '2 Latte cups' marking is the maximum capacity
(approximately 400ml).
www.KALORIK.com
7
MFH 43974 - 200505