Mark INFRA ZONE CONTROL Livret Technique page 6

Make sure the power is off before connecting the wiring. If this is not the case, the power must
be turned off before proceeding. When switching off the power of the device the technical book/
operation manual should be taken into account.
Connect the Infra zone control according to the electrical diagram at the end of this chapter.
Diameter Length
0.8mm 2 80 meter
1.0mm 2 100 meter
1.5mm 2 150 meter
3.3 Check connection controller and display
When the display and controller are connected properly through CAN-bus connections, the
lowest green LED will blink.
6
It is recommended that a protected cable is used here.