Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
A
22 English
WA3100M_DC68-03850A-04_EN.indd 22
B
1. Connect the ends of the water supply
2. Tighten the fittings by hand until they
When you fasten the fittings, do not fasten
them too tightly or apply tape or sealant to
the faucets or water supply intakes. This can
damage the fittings.
After you have connected the water supply
hoses to the faucets, ensure that they are
connected correctly by pulling the water
supply hoses downwards.
3. Place the unconnected ends of the hoses
hoses to the hot and cold faucets.
are snug, and then tighten them an
additional two-thirds of a turn with a
plier.
CAUTION
NOTE
into a bucket and open the faucets
connected to the two water supply hoses
for 10 or 15 seconds to remove any
foreign substances from the hoses. Close
the faucets before continuing.
2018-09-05
3:32:51
Publicité
Table des Matières
