Scuddy 00702 Mode D'emploi page 31

4. Place the battery pack (17) down on a dry, fl at, fi rm and heat-resistant surface close
to a plug socket.
5. Connect and charge the battery in the manner described in the previous section
(points 3 - 8).
Insert the battery pack
1. Make sure that the battery is switched off. The operating lamp on the rocker switch (k)
must not be lit. If it is lit up, press the rocker switch (k) on the battery pack (17) at the
back left to switch off the battery.
2. Insert the battery pack:
– Slide the battery pack in between the steering rod (7) and foot board (12). The
recess on the battery pack (17) must be seated on the steering rod (7).
– Press down in the middle of the scooter until the battery pack (17) forms a fl at
surface with the foot board (12).
– Lock up the lock for the battery pack (16) with the key and remove the key.
Speedometer Display
The battery must be switched on to switch on the speedometer display (1) and
make settings!
Switch the scooter on / off
• Hold down the ON / OFF button (d) for around 3 seconds. The speedometer dis-
play (1) switches on. The scooter is now ready to start.
• To switch the scooter off again, hold down the ON / OFF button (d) again for around
3 seconds. The speedometer display (1) switches off. The scooter cannot be started.
Switch the light on / off
The speedometer display (1) must be switched on to switch on the light!
• Press the ON / OFF button (d) for a short time. The front light (23) and rear light / brake
light (11) switch on.
• To switch both lights off again, press the ON / OFF button (d) again for a short time.
Speed display (a)
• Shows how fast the scooter is travelling in km/h.
Speed intervals
• The scooter has three different speed intervals. Depending on the speed interval
which is set, the scooter can only accelerate up to a specifi c speed:
ECO - low speed, up to 30% of the maximum speed
MID - medium speed, up to 50% of the maximum speed
HIGH - high speed, up to 100% of the maximum speed
• You can switch between the different speed intervals by pressing the M button (e).
• The speed interval that is set is shown on the speedometer display (g-i).
00702_DE-EN-FR-NL_A5_V3.indb 31 00702_DE-EN-FR-NL_A5_V3.indb 31
All manuals and user guides at all-guides.com
31
3. Insert the large barrel connector back into the large barrel
connector socket (l) on the battery pack (17) and turn it
slightly clockwise until the locking catch engages.
EN
05.09.2016 09:15:10 05.09.2016 09:15:10