Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. Changing and Saving Timing Set Value
Main Operation Screen
When Enter button pressed ''S'' led will
be active and temperature set value will
be displayed.
When Enter button pressed Timing set
value can be saved.
Timer set value parameter (Default=01:00)
Timer set value, can be programmed between minimum Timer set value 00:01 and
set limit.
6.1 Programming Mode Parameter List
Filter Time of Digital Inputs ( Default = 100 )
It is used for protection against the electrical contact debounce or the signal that is less than
the determined pulse time.
It can be adjusted from
Time Unit and Scale Selection
Start Type Selection Parameter ( Default =
Output Functions
Hour / Minute
It can be adjusted from
Minute /Second
It can be adjusted from
Second /10 Milisecond
It can be adjusted from
Start / Stop buttons can be used to run or stop the timer.
Start / Stop buttons can be used to run or stop the timer.
External Start Input can be used to run or stop the timer.
External Start Input can only be used to run the timer. In order to stop the timer
the Stop button must be used.
For detailed information refer to graphics.
(Default =
if ON is selected timer runs by start and relay contact is closed. When time is
over, relay contact opens.
if OFF is selected timer runs by start. When time is over, relay contact is closed.
''S'' will be inactive and goes back to
to
msec .
Parameter
( Default = 1 )
to
.
to
.
to
.
)
)
SET Value Screen
Timer set value can be
changed with increment and
decrement buttons.
Main Operation Screen
main operation screen.
maximum
8
Publicité
Table des Matières
