EMKO EZM-3735 Mode D'emploi page 14

6.5 Entering To The Programming Mode, Changing and Saving Parameter
Main Operation Screen
When Enter button is pressed for 5
seconds, "P" led starts to blink. If
programming mode entering
password is different from 0,
programming mode entering screen
will be observed.
Password Entering Screen
Enter programming mode accessing password
with increment and decrement buttons.
Note2: If programming mode accessing password is 0, only three parameters
are accessible, and the parameter values can be changed.
Programming Screen
Press Enter button for accessing to the parameter
value. Press increment button for accessing to the
next parameter, press decrement button for
accessing to the previous parameter.
Filter Time of Start Input
Press OK button for saving
the parameter.
i
If no operation is performed in programming mode for 20 seconds, device turns to main
operation screen automatically..
PAUSE
ü
Note1: If programming
mode accessing
password is 0,
Temperature Unit screen
is observed instead of
programming screen
PAUSE
ü
PAUSE
ü
PAUSE
ü
Programming Mode
Entering Screen
Press Enter button for
accessing to the
password entering
Password Entering Screen
Press OK button for entering
the password.
Filter Time of Start Input
Change the value with increment
and decrement buttons.
Filter Time of Start Input
Press increment button for accessing to the
next parameter, press decrement button for
accessing to the previous parameter
PAUSE
ü
screen.
PAUSE
ü
PAUSE
ü
PAUSE
ü
14