Selecting A Location; Adjusting The Leveling Feet; Removing The Transit Bolts; Connecting The Water Supply Hose - Samsung WF-J1254 Instructions D'utilisation

Selecting a location

Before you install the washing machine, select a location with the following characteristics:
•
A hard, level surface (if the surface is uneven, see "Adjusting the leveling feet, " below)
• Away from direct sunlight.
• Adequate ventilation
• Room temperature that will not fall below 0 ˚C
• Away from sources of heat such as coal or gas
Make sure that the washing machine does not stand on its power cord.
Ventilation openings must not be obstructed by carpeting when the washing machine is installed on a
carpeted floor.
THE MINIMUM CLEARANCES FOR CLOSET AND ALCOVE INSTALLATIONS - SIDES 0 IN., REAR 1 IN. TOP
2 IN., CLOSET FRONT 0 IN.
Closet front must have two unobstructed air openings combined total area 72 sq.in.min. located 3 in.
front top and bottom. Louvered door with equivalent air opening is acceptable.

Adjusting the leveling feet

If the floor is uneven, adjust the feet (do not insert pieces of wood or any other objects under the feet):
1. Loosen the leg bolt by turning it with your hand until it is at the desired height.
2. Tighten the locking nut by turning it with the supplied wrench.
• Place the washer on a sturdy, flat surface.
If the washer is placed on an uneven or weak surface, noise or vibration occurs.
(Only a l degree angle is allowed.)

Removing the transit bolts

Before using the washing machine, you must
remove the five transit bolts from the back of the
unit.
To remove the bolts:
1. Loosen all bolts with the supplied wrench before removing them.
2. Take each bolt head and plastic together, pull it through the wide part of the hole.
Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the transit bolts for future use.

Connecting the water supply hose

The water supply hose must be connected to the
washing machine at one end and to the water
faucet at the other. Do not stretch the water
supply hose. If the hose is too short and you do
not wish to move the water faucet, replace the
hose with a longer, high pressure hose.
To connect the water supply hose:
1. Take the L-shaped arm fitting for the water
supply hoses and connect to the water
supply intake on the back of the machine.
Tighten by hand.
WF-J1254-02212V_EN.indd 2
Installing the Washing Machine
Remaining Time
12:00
Check
Temp
SAMSUNG Washing Machine Owner's Instructions B-2
Cotton
Synthetic
Pre-wash
Delicate
o C
Wash
Wool
rpm
Rinse Power
Min
Speedy START
Spin PAUSE
Delay Start Eco
Fuzzy control Door open
Spin Delay Start Function
2007-01-02 ｿﾀﾈﾄ 1:29:58