Electrical Connections - Viking Range 5 Serie Mode D'emploi

ELECTRICAL CONNECTIONS

OPTIONAL ELECTRICAL KITS
Each accessory includes 6 feet of wiring (coiled inside the back of the accessory) to connect the accessory to a Viking Range,
LLC grill. Additionally, 2 specialized electrical kits are available to purchase for your accessory, depending upon how it will be
installed. Each electrical kit ships with an instructional sheet for assembly. Assembly instructions and schematics/drawings can
also be found on our website at www.vikingrange.com.
• LASK Accessory Switch Kit
• LPEK Power Extension Kit
Installation requires an outdoor 120VAC 15A GFI (Ground
Fault Interrupter) electrical outlet adjacent to the accessory.
The GFI outlet features an internal breaker that reduces
shock hazard. This type of outlet should be installed by a
qualifi ed electrician either inside the island enclosure for
built-in units, or near the location where a free-standing unit
will be used.
For built-in accessories, the supplied 12V transformer is
connected to the accessory during installation.
If the electrical system fails to operate, a connection may
have come loose in shipping or the GFI may have tripped,
requiring a reset. See the Troubleshooting section for more
details.
This switch and transformer kit allows independent control of a accessory burner
without connection to a grill. The kit contains a transformer and mounting bracket
as well as a switch assembly with a mounting plate.
The Power Extension Kit provides 12 feet of additional wire between your grill and
accessory burner.
CONNECTING THE WIRING
The accessory electrical harnesses are designed to
provide power for both ignition and lighting. While ignition
is controlled at the accessory, lighting is controlled at the
grill.
You can control lighting at the accessory by installing the
Accessory Light Switch (LASK).
Disconnect the 4-pin connector on the grill and connect
those plugs to the mating plugs on your accessory. (See
Index "Electrical Connections)
Important note: If using multiple accessories with the
Control Illumination/Blue LED'S, a connector for this
purpose is built into the accessory wiring. This will allow you
to use the light switch on your grill to actuate the power on
more than one accessory.
SIDE BURNER ACCESSORY CARE & USE/INSTALLATION
|
13