Olsberg 14/71-3 Serie Notice D'utilisation page 24

•
Close the heater:
Firmly fix the side panels to the upper right and left
side inner cabinet using the screws.
Replace the room thermostat knob.
Set the front panel on the upper lip of the heater
rear panel in such a way that the tabs in the front
panel fit into the slots in the rear panel.
Tilt the front panel downwards so that the fixing
brackets on the lower left and right hand sides of
the front panel fit between the inner cabinet and
the side panels.
Please ensure, that between front and side
panels the circumferrending gap has a con-
stant width! The inside of the front panel is
then closely attached to the edges of the side
panels!
Secure the fixing screws. It is essential that both
screws are fixed to ensure earth continuity.
Replace the plastic covering caps.
fig.26
Important instructions for installation and
operation
•
The electrical installation of this heater must be
approved by your local electricity company.
•
The installation must be carried out by a competent
electrician in accordance with I.E.E. regulations.
•
Local safety regulations must also be adhered to.
•
Following tests must be carried out before
commissioning the heater
- Insulation test with a voltage of at least 500V.
The dielectric resistance must be at least
0,5MOhm.
- The electrical installer must measure the power
draw of the elements. This can be done using a
kW and time measurement or alternatively by
measuring the cold element resistance. The
value is to be compared with that of the rating la-
bel or in the 'Technical Data' Section.
24
All manuals and user guides at all-guides.com
•
The storage heater is only to be used in rooms
where neither explosive gases (e.g. from floor-
sealant), nor inflammable dust is present!
•
Electrical appliances conform to valid safety regu-
lations. Repairs and service to electrical appliances
must only be carried out by a competent electri-
cian. Improper repair can mean distinct danger to
the user.
•
As the surfaces of the heater cabinet get hot in
use, flammable or other objects presenting a dan-
ger of fire must not be placed on, or near the
heater.
Do not, therefore, place any wooden objects,
clothes or washing, newspapers, blankets or the
like on or over the heater and do not put any
pieces of furniture made of inflammable materials,
nor spray tubes or similar objects closer than 25cm
in front of, or on the heater, especially not in front
of the air-outlet grille.
•
It is important to remember that the surfaces of the
heater can reach temperatures in excess of 80°C
(60K) during operation.
•
The storage heater is designed to need very little
maintenance.
•
Cleaning and maintenance intervals are very de-
pendent on the respective circumstances sur-
rounding installation and operation. We recom-
mend that the first inspection take place at the lat-
est before the second heating period. Further
maintenance intervals can then be set according to
individual circumstances.
•
Heater surfaces must not be cleaned with any
scouring or soft-scrub materials. Only use normal
household cleaning liquids.
•
Heaters that have already been in operation or
have been taken apart and repositioned must be
re-installed according to these instructions. The
commissioning tests described on this page must
also be carried out.
- Any insulation parts which are, or seem to be,
damaged or have changed properties which
could influence their function and safety, must
be replaced by new ones.
•
Packaging materials, replaced parts and decom-
missioned appliances and/or parts must be dis-
posed of correctly.
•
This heater is not intended for operating by per-
sons (including children), with reduced physical,
sensory or mental abilities or for lack of experience
and/or for lack of knowledge to be used it by a per-
son responsible for their security is supervised or
received from instructions like the heater to use.
Children should be supervised, in order to guaran-
tee that they do not play with the heater.