Replacing The Lamp; Noises; Closing The Door - AEG SCE81911TS Notice D'utilisation

32 www.aeg.com
Problem
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

9. NOISES

There are some sounds during normal running (compressor, refrigerant circulation).
OK
All manuals and user guides at all-guides.com
Possible cause
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The "FROSTMATIC func-
tion" or "COOLMATIC
function" is switched on.
There is no cold air circula-
tion in the appliance.
Solution
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "FROSTMATIC func-
tion" or "COOLMATIC func-
tion".
Make sure that there is cold air
circulation in the appliance.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
HISSS!
BRRR
!