AEG SCE81911TS Notice D'utilisation page 31

All manuals and user guides at all-guides.com
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC" or "COOLMATIC", or af-
ter changing the tempera-
ture.
Water flows on the rear
plate of the refrigerator.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
Possible cause
The door is not closed cor-
rectly.
The "FROSTMATIC" or
"COOLMATIC" is switch-
ed on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost
melts on the rear plate.
Food products prevent the
water to flow into the wa-
ter collector.
The water outlet is clog-
ged.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The "FROSTMATIC func-
tion" or "COOLMATIC
function" is switched on.
ENGLISH
Solution
Refer to "Closing the door".
Refer to "FROSTMATIC func-
tion" or "COOLMATIC func-
tion".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" .
The compressor starts after a
period of time.
This is correct.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water out-
let to the evaporative tray.
Switch off "FROSTMATIC
function" or "COOLMATIC
function" manually, or wait un-
til the function resets automat-
ically to set the temperature.
Refer to "FROSTMATIC func-
tion" or "COOLMATIC func-
tion".
31