Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DUE TO VARYING ANGLES OF VEHICLE SEAT BELT
RETRACTORS, EXCESS SLACK IN THE VEHICLE BELT
SYSTEM MIGHT NOT BE REMOVED AUTOMATICALLY.
Once the lap and shoulder portions of the seat belt
are properly positioned and the buckle is attached,
FEED ANY REMAINING SLACK OF THE SEAT BELT
MANUALLY BACK INTO THE RETRACTOR TO TIGHTEN
THE WHOLE SYSTEM.
1. Place booster seat firmly against the back of a
forward-facing vehicle seat. The vehicle seat MUST
be equipped with a 3-point lap-and-shoulder belt.
Booster must be level, stable and not rock side-to-
side (see "Vehicle seating positions").
2. Place child in the booster seat with child's back flat
against the back of the booster seat.
3. Adjust headrest height so that the bottom of the
headrest is EVEN with the top of the child's shoulders.
See "Adjusting headrest".
4. Thread shoulder belt portion
of
the
shoulder belt system through
the shoulder belt guide ❶
and ensure that shoulder belt
lies across child's shoulder and
chest, and NOT across child's
face or neck.
5. Thread both sides of the lap belt under BOTH armrests.
Thread the lower end of the shoulder belt under the
armrest on the buckle side ❷. ENSURE that the
belt is snug across the child's hips. It is important to
ensure that any lap strap is worn low down, so that
23
INSTALLATION
WARNING!
!
3-point
lap-and-
❶
❷
Publicité
Chapitres
Table des Matières
