Tefcold SSF150 Mode D'emploi page 34

Dixell XR20CX (SSF Series)
PAR. DESCRIPTION
Set Set point
Hy diFferential. Relay compressor tripping differential. The compressor stops on reaching the
Setpoint value, and restarts at temperature equal to the Setpoint plus the value of the
differential.
LS Lower SEt. Minimum possible setpoint value.
US Higher SEt. Maximum possible setpoint value.
Ot CAlibration 1.Calibration 1. Positive or negative temperature value added to the value
read by probe 1, based on "ot" parameter settings.
P2P Second probe presence: n=not present, y=present
oE CAlibration 2.Calibration 2. Positive or negative temperature value added to the value
read by probe 2, based on "P2" parameter settings.
odS delay (at) On compressor. Delay time in activating the compressor relay after switch-on of
instrument.
AC Anti short cycle delay
CON On time (compressor). Compressor activation time in the event of faulty probe.
COF OFF time (compressor). Compressor in disabled state time in the event of a faulty probe.
CF Measurement units: °C=Celsius, °F=Fahrenheit
rES Resolution (only for °C): dE=decimal between -9.9 and 9,9; in=integer
Lod Default display: P1=thermostat probe, P2=evaporator probe, SP=Set point
td defrost type. Type of defrosting.
El = electric defrost.
in = reverse cycle defrost (hot gas)
dtE Defrost termination temp.
idF defrost interval time. Interval between the start of two successive defrosting operations.
MdF Max length for defrost
dFd Display during defrost: rt=real temp. it=start defrost temp., St=Set point, dF=llabel Df
dAd Max display delay after defrost
dAF Defrost delay after fast freezing
ALc Temperature alarm configuration: rE=relative to SET, Ab=absolute
ALU Higher ALarm. Maximum temperature alarm. Temperature value.
which if exceeded in an upward direction triggers the activation of the alarm signal.
ALL Lower ALarm. Minimum temperature alarm. Temperature value.
which if exceeded in a downward direction, triggers the activation of the alarm signal.
ALd Temperature alarm delay
dAO Exclusion of temperature alarm at startup.
PbC Kind of probe
RANGE DEFAULT
LS-US -22
0.1...25.0 2,0
-55.0...HSE -2
LSE..302 -5,0
-9.9...9.9 0
n/y N
-9.9...9.9 0
0...99 2
0...50 5
0...99 10
0...99 10
°C/°F °C
dE-in dE
P1,P2,SP P1
EL/in In
-50...50 6
0...99 0
0...99 0
Rt/it/SP/dF St
0...255 1
0...23 0
rE/Ab rE
AL...99 10
-55...AU -1
0...99 20
0..23 1
Ptc/ntc Ntc
U.M.
°C/°F
°C/°F
°C/°F
°C/°F
°C/°F
flag
°C/°F
min
Min
min
min
°C/°F
flag
flag
flag
°C/°F
hours
min
flag
Min
hours
Flag
°C/°F
°C/°F
min
hour
flag
34