Parts And Functions - Haier AS09GN3ERA Mode D'emploi

Parts and Functions

Indoor Unit
Inlet
1 1
Inlet grille
2 2
3 3 Outlet
Anion generator
5
Vertical blade
6 6
(inside)
(adjust left and
right air fl
7
Horizontal flap
(adjust up and down air flow
Don't adjust it manually)
9 Power indicator
(Lights up when unit starts.)
10 Timer mode indicator
(Lights up whenTimer operation is selected.)
Operation mode indicator
11
(lights up when the compressor is on.)
12 Remote signal receiver
(A beeping sound is generated when a signal
from remote controller isreceived.)
Ambient temp display
13
When receiving the remote control signal, display the set
temperature and in the rest time the room temperature is
displayed and this room temperature is only for reference.
Actual inlet grille may vary from the one shown in the
manual according to the product purchased
Outdoor Unit
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
INLET
Please be subject to the actual produce purchased the
above picture is just from your reference
Air Purifying Filter
4
(inside)
8
Emergency
Switch
9
10
12
11
13
ow)
4
Remote controller
1 6
2
7
3
4
5
8
9
18
10
19
11
20
12
21
13
22
14
23
15
24
16
25
17
1. Mode display
Operation mode
AUTO COOL DRY FAN HEAT
Remote controller
2. Signal sending display
3. SWING display
4. FAN SPEED display
Display
circulated
LO MED HI AUTO
5. LOCK display
6. TIMER OFF display
TIMER ON display
7. TEMP display
Healthy function is not available for some units.
Loading of the battery
1
3
4
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change- over
type fluorescent lamp or wireless telephone is installed in the
room, the recei ver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batte ries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please
reload several minutes later.
remove the batteries and
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking out, just press reset key.
Additional functions display
8.
Supplemented
electrical
Operation mode
QUIET SLEEP HEALTH
heating
Remote contro ler
9. QUIET button
10. HEAT button
11. COOL button
12. AUTO button
13. FAN SPEED button
14. TIMER button
15. HEALTH button
16. LOCK button
Used to lock buttons and LCD display
17. LIGHT button
Control the lightening and extinguishing
of the indoor LED display board.
18. POWER ON/OFF button
19. DRY button
20. TEMP button
21. SWING button
22. HOUR button
23. EXTRA FUNCTION button
Function: Sleeping Healthy
airflow position1 Healthy airflow
position 2 Power Air sending
A B yard
24.CANCEL/CONFIRM button
Function: Setting and cancel to the
timer and other additional functions.
25. RESET button
When the remote controller appears
abnormal, use a sharp pointed
article to press this button to reset
the remote.
Remove the battery cover;
2
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Be sure that the loading
e" + "/"-";
is in line with th
TURBO
11