Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connecting Your System
There are four ways to connect the receiver to your existing TV system. We recommend using one of the
following cases for the best result:
1.
If you have a high definition television set, you should use a HDMI cable for best result. Plug one
end of the cable into the HDMI socket on the receiver and the other end into the matching socket
on your television. In this case, you do not have to make audio connections because the HDMI
connector can output stereo audio or Dolby digital audio.
2.
Connect one end of RCA cable to the RCA jack on the back of the receiver and the other end to a
RCA jack on your TV.
Finally connect the coaxial cable from the LNB to the Input on the receiver.
TV with Motorized System (DiSEqC 1.2 / USALS)
Connect one end of your coaxial cable to the LNB IN connector on the receiver and the other end to the
Receiver connector on the DiSEqC 1.2 / USALS motor.
Connect the coaxial cable from the LNB to the LNB connector on the DiSEqC 1.2 / USALS motor.
All our receivers are designed to be DiSEqC 1.0 / DiSEqC 1.2 /USALS compatible.
This allows multiple antennas to be connected to the receiver at the same time.
If you have two or more fixed antennas or LNBs, we recommend you use a DiSEqC 1.0 switch. Connect
the coaxial cable from the first LNB to the LNB 1 or LNB A input connector of the DiSEqC switch. Do the
same for any other LNBs that you have.
Connect one end of a coaxial cable to the RF output connector of the DiSEqC switch,
Connect the other end to Input on the receiver.
All manuals and user guides at all-guides.com
6
Publicité
Table des Matières
