Table des Matières
Publicité
3.
Position the Frame
Secure Legs
Sécuriser les pieds
Fije las patas
Measure and mark.
Mark
X-[3/4" (1.9 cm)]
corner.
Mesurer et marquer.
Marquer
X-[3/4" (1,9 cm)]
le coin.
Mida y marque.
Marque la
X-[3/4" (1,9 cm)]
esquina.
Drill 3/8" holes.
Percer des trous de 3/8".
Taladre orificios de 3/8".
Secure the Legs
Position the console frame upside down in the installation location.
Mark the corners of each leg onto the floor.
NOTE: To properly secure the console table, the marked holes must be centered
below the levelers.
From the marked corners, measure then mark the baseboard thickness (if present)
then subtract 3/4" (1.9 cm). Measure again to confirm that the marked holes will
be centered below the levelers.
Drill a 3/8" pilot hole that is 3/4" (1.9 cm) deep at each mark. Remove any debris.
Turn the console table upright, then insert the levelers into the holes.
Check the console table for level. If necessary, turn the levelers to achieve level.
Secure the Frame
WARNING: Risk of property damage. Select 250 lb (113.4 kg) load bearing lag
bolts with a length that can safely clear any obstacles in the wall. Calculate the
proper length of the lag bolts by adding the following: 1-1/2" (3.8 cm) bracing +
wall board thickness + bracket thickness.
Drill pilot holes through the mounting holes of the frame, finished wall, and
bracing.
Secure the frame to the finished wall with fasteners (not provided).
Kohler Co.
All manuals and user guides at all-guides.com
Measure baseboard
thickness = X
Mesurer l'épaisseur
de la plinthe= X
Mida el espesor del
zócalo = X
9
Secure Frame
Sécuriser le cadre
Fije la estructura
Drill then secure
with fasteners.
Percer puis sécurise
ravec des fixations.
Taladre luego fije
con herrajes.
Leveler
Vérin de mise à niveau
Nivelador
1106925-2-B
Publicité
Table des Matières
