Specific Safety Rules - Harbor Freight Tools PACIFIC HYDROSTAR 95672 Instructions D'assemblage Et Mode D'emploi

PROPER USE OF PRESSURE WASHER
THIS UnIT IS InTEnDED TO BE USED WITH cOLD WATER OnLY! DO nOT USE
Operate the Pressure Washer at no more than the fluid pressure rated for the
1.
Pressure Washer. Never run the Pressure Washer without a water supply. Running
the unit without a water supply will cause irreparable damage to the unit.
2. Make sure the water supply you use for the Pressure Washer is not dirty, sandy,
and does not hold any corrosive chemical products. Using a dirty water supply will
compromise the long life of the Pressure Washer.
. cAUTIOn: The Pressure Washer can be used for a variety of applications, including
cars, boats, decks, garages, etc. where high pressure is necessary to remove dirt
and debris. The high pressure water flow can damage the work surface if not
used properly. See the Section "Operating Instructions" for more details. Always
test the spray in an open area first.
4. NEVER move the unit by pulling on the high pressure hose. Use the handle provided
on the top of the unit.
5. Always hold the high pressure gun and wand with two hands. Keep one hand on
the gun/trigger while supporting the wand with the other hand.
1. Avoid accidental starting. Be sure the Power Switch is off before plugging in.
Plugging in power equipment with the Power Switch on, invites accidents.
2. Use safety equipment. Always wear AnSI-approved safety impact eye gog-
gles.
. Do not use if the Power Switch does not turn it on or off. Any tool that cannot be
controlled with the Power Switch is dangerous and must be replaced.
Disconnect the Power cord Plug from the power source before making any
4.
adjustments, changing accessories, or storing the tool. Such preventive safety
measures reduce the risk of starting the tool accidentally.
Store idle tools out of reach of children and other untrained persons. Tools
5.
are dangerous in the hands of untrained users.
check for breakage of parts and any other condition that may affect the tool's
6.
operation. If damaged, have the tool serviced before using. Tag damaged tools
"Do not use" until repaired.
Use only accessories that are recommended by the manufacturer for your
7.
model. Accessories that may be suitable for one tool may become hazardous
when used on another tool.
For technical questions, please call 1-800-444-3353;
SKU 95672
All manuals and user guides at all-guides.com
HOT WATER In THIS PRESSURE WASHER.

SPEcIFIc SAFETY RULES

Troubleshooting section at end of manual.
PAGE 6