Controls And Features - Harbor Freight Tools PACIFIC HYDROSTAR 95672 Instructions D'assemblage Et Mode D'emploi

10. Insert the Detergent Tube (27) into an approved container of liquid detergent (not
included). (See Figure B.)
Motor Regulating Switch (37). The Motor () of this Pressure Washer does not
1.
run continuously, but only when the Trigger is squeezed. After following the start-up
procedures in this manual, turn the Pressure Washer on and squeeze the trigger
for activation. See Section titled "Operating Instructions" for more details on the
automatic On/Off feature.
2. Bleeding the gun. It is very important to bleed the gun before using the Pressure
Washer. Refer to the "Assembly Instructions" to assemble the Pressure Washer. To
bleed the gun, simply connect the garden hose to the Pressure Washer and squeeze
the Trigger BEFORE turning the electrical supply on. This allows any air trapped
inside the Pressure Washer and gun to be removed before using the unit. Continue
holding the Trigger for approximately one minute to allow any excess air out of the
unit. Water will flow through the gun at low pressure during this procedure. For more
bleeding tips, see the Section titled "Operating Instructions."
RESET
BUTTOn
TEST
BUTTOn
ground Fault circuit Interrupter (gFcI). This unit is equipped with a Ground
.
Fault Circuit Interrupter (GFCI). When connecting the GFCI to the receptacle, the
indicator will be tripped and will not appear red. Depress the RESET button on the
GFCI until the indicator appears red. If the indicator does not appear red after doing
this, please see Section titled "Troubleshooting" for more information. This Pres-
sure Washer is provided with a GFCI built into the plug of the power supply cord.
This device provides additional protection from the risk of electric shock. Should
replacement of the plug or cord become necessary, use only identical replacement
parts that include GFCI protection. (See Figure c.)
For technical questions, please call 1-800-444-3353;
SKU 95672
All manuals and user guides at all-guides.com

cOnTROLS AnD FEATURES

gFcI POWER PLUg (14)
Troubleshooting section at end of manual.
RED
InDIcATOR
FIgURE c
REV 07f
PAGE 10