HoMedics MCS-1200H Mode D'emploi page 3

INSTRUCTIONS FOR USE
Plug the receptacle end into the input jack, located near the side of the massager and plug
included adapter into a 120-volt AC outlet.
1. Assemble chair according to set up instructions included in the box with your unit.
2. Once your chair is set up, you can start enjoying the 3D shiatsu massage mechanism according
to directions on pages 8-9.
3. You may choose to lift the fabric flap and let it hang behind the seat back for a more intense
massage.
4. Your chair can also be utilized for seating without the massage mechanism activated.
Note: The hand control comes with a clear, plastic film to protect the buttons before use. When you
are ready to use your massage cushion, peel off the plastic film by lifting at one corner and pulling
gently. Discard film.
Caution: To avoid pinching do not lean on the back massage mechanism in the chair when
adjusting your body position.
Do not jam or force any part of your body in the moving massage mechanism.
Note: There is a 15-minute auto shut off on the unit for your safety.
4
MAINTENANCE
TO STORE
Avoid contact with sharp edges or pointed objects which might cut or puncture the fabric surface.
To avoid breakage, do not wrap the power cord around the unit.
TO CLEAN
Unplug the unit and allow it to cool before cleaning. Clean only with a soft, slightly damp sponge.
Never allow water or any other liquids to come into contact with the unit.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, gasoline, kerosene, glass / furniture polish or paint
thinner to clean.
• Do not attempt to repair the Massage Chair. There are no user serviceable parts. For service, call
the Consumer Relations telephone number listed in the warranty section.
NOTE: Only gentle force should be exerted against the unit in order to eliminate any/all risk of
injury. You may soften massage force by placing a towel between yourself and the unit.
5