Installation Instructions; Installation Requirements; Ventilation Requirements - ARTHUR MARTIN AUT700AOW Manuel De L'utilisateur

Symptom
Noise

INSTALLATION INSTRUCTIONS

It is dangerous to alter the specifications or
attempt to modify this product in any way.

Installation requirements

To ensure correct operation this
appliance must not be located where the
temperatures will fall below 16°C or rise
above 32°C. Avoid the following locations:
unheated kitchen, outhouse, conservatory,
garage. For correct operation this
appliance must be installed:
• In a dry atmosphere.
• Out of direct sunlight.
• Away from extreme temperature
(not next to a cooker or other
sources of heat).
Your appliance will be heavy when loaded
with food and must therefore be stood on
a strong firm floor.

Ventilation requirements

Gently push into place until the top panel
rear ventilation grille touches against the
wall. When in position a 50mm (2") clear
space above the appliance should be
maintained. If space above the appliance
is not available, clearance of 25mm should
be maintained on both sides.
Ensure that the appliance does not stand
on the electrical supply cable.
All manuals and user guides at all-guides.com
Solution
Refer to normal operating sounds.
If after the above checks there is still a fault call
your local Service Force Centre.
In-guarantee customers should ensure that
the above checks have been made as the
engineer will make a charge if the fault is not
a mechanical or electrical breakdown. Please
note that proof of purchase is required for
in- guarantee service calls.
Check the thermostat is turned to the correct
setting relative to ambient conditions.
Check the ambient temperature is within the
controllers.
The compressor runs continuously.
Adjust the thermostat to give correct temperature.
Parts which heat up should not be
exposed. Whenever possible, the back of
the appliance should be close to a wall but
leaving the required distance for ventilation.
Leveling: The appliance should be level.
Rocking: Ensure the appliance is upright
and both adjusters are in firm contact with
the floor so that the cabinet is level. Adjust
the level by screwing out the appropriate
level adjuster at the front, (use your
fingers or a suitable spanner).
This appliance is heavy. Care should be
taken when moving it.
Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on
the rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided with
a contact for this purpose. If the domestic
power supply socket is not earthed,
connect the appliance to a separate earth
in compliance with current regulations,
consulting a qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the E.E.C.
Directives.
9