Product Description; Before Use; Control Unit; Using The Appliance - ARTHUR MARTIN AUT700AOW Manuel De L'utilisateur

Care and cleaning
WARNING! Risk of injury
or damage to the appliance.
• Before maintenance, deactivate the
appliance and disconnect the mains
plug from the mains socket.
• This appliance contains hydrocarbons
in the cooling unit. Only a qualified
person must do the maintenance and
the recharging of the unit.
• Regularly examine the drain of the
appliance and if necessary, clean it.
If the drain is blocked, defrosted water
collects in the bottom of the appliance.

PRODUCT DESCRIPTION

Control Unit

Storage
Backets
Control unit
MAX
NORMAL

Using the appliance

This appliance is designed for domestic
use only, specifically for the storage of
edible foodstuff. This appliance is designed
to operate in ambient temperatures
(surrounding air temperature) between
16°C and 38°C. If these temperatures
All manuals and user guides at all-guides.com
Door
MIN
Disposal
WARNING! Risk of injury
or suffocation.
• Disconnect the appliance from the
mains supply.
• Cut off the mains cable and discard it.
• Remove the door to prevent children
and pets to be closed inside of the
appliance.
• The refrigerant circuit and the insulation
materials of this appliance are ozone-
friendly.
• The insulation foam contains flammable
gas. Contact your municipal authority
for information on how to discard the
appliance correctly.
• Do not cause damage to the part of
the cooling unit that is near the heat
exchanger.
are exceeded i.e., colder or warmer, the
appliance will not operate correctly. Should
the ambient temperatures be exceeded
for long periods, the temperature in the
freezer compartment will rise above -18°C
and food spoilage may occur.

Before use

Remove all securing tapes. Wash the
inside of the appliance with lukewarm
water with a little bicarbonate of soda
added (5ml to 0.5 litre of water). Do not
use soap or detergent as the smell may
linger. Dry the appliance thoroughly.
To Start the appliance
1. Allow the appliance to stand for
2 hours after installation.
2. Plug in the appliance and switch
on at the mains supply.
3. Turn the thermostat control to the
required setting. A midway setting is
usually suitable for normal operation
(see thermostat control).
4. Leave the appliance for approximately
4 hours for the correct temperature to
be reached before placing food inside.
5