AEG SFE81821DS Notice D'utilisation page 30

30 www.aeg.com
Problem
The appliance is noisy.
Audible or visual alarm is on. The cabinet has been re-
A symbol or
shown instead of numbers
on the Temperature Display.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
Possible cause
The mains plug is not con-
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not sup-
ported properly.
cently switched on or the
temperature is still too
high.
The temperature in the ap-
pliance is too high.
The door is left open.
The temperature in the ap-
pliance is too high.
Temperature sensor prob-
symbol is
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FROSTMATIC is
switched on.
The COOLMATIC is
switched on.
Solution
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Door open alarm".
Refer to "Door open alarm".
Close the door.
Contact a qualified electrician
or contact the nearest Author-
ised Service Centre.
Contact the nearest Author-
ised Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "FROSTMATIC func-
tion".
Refer to "COOLMATIC func-
tion".