Anti-Collision Safety Feature; Energy Preserving Feature - ergoCentric upCentric Guide De L'utilisateur

How to Set a Memory Postion
Use the up and down buttons to adjust table to the desired height.
Hold the up button and the desired memory button (1, 2, 3 or 4) together
until it beeps and P1, P2, P3 or P4 is shown on the display screen.
How to Move Table to a Saved Position
Press and hold the memory button (1, 2, 3 or 4) until the table adjusts to the
saved position.

Anti-Collision Safety Feature

The control box for the upCentric table frame includes an anti-collision function
which may reduce damage to the table in the event of collision with a firm
object. When the table is raised/lowered, the power consumption of each leg is
monitored and compared to a predetermined value. If the power consumption
for the legs is increased relative to a predetermined value, the system assumes
that there is an obstruction (collision) and the table will stop and then run in the
opposite direction up to three inches.
The sensitivity of this anti-collision feature is different when moving downwards.
The anti-collision activates with an applied force of 45lbs (20kg) when moving
upward, or with an applied force of 85lbs (38.5kg) + weight of the tabletop and
what is placed on the table when moving downward.
Situations where the anti-collision is not activated :
• If the collision occurs during the reset operation.
• If the collision occurs within the first 2 seconds after de-activating
the handset.
• If the collision occurs downwards and the load on the table
and what is placed on the desktop is less than 85lbs (38.5kg)
• If the collision is not with a solid object.

Energy Preserving Feature

When the upCentric table is left in position for more than 3 minutes, it will go
into standby mode in order to reduce energy consumption. When adjusting
your table after a dormant period, hold the up or down button to take table
out of standby mode.
All manuals and user guides at all-guides.com
13