KORTING HI 6450 RI Notice D'utilisation page 33

Error code: Description:
C The cooking zone can be conig-
ured if a static "C" is shown.
C/-
The cooking zone will be conig-
ured if a blinking "C" is shown.
After a successful coniguration
the relevant display shows "-".
When the "-" is not displayed
please check the possible causes
of the E/5.
E
A blinking "E" on each cooking
zone indicates, that all configs
will be deleted.
E/2
Temperature limits are excessed. Electronik temperature to high.
E/3
Unsuitable pot.
E/4 Unconigured induction modul.
E/5 No communication between UI
and induction modul.
E/6 Main power disturbance.
E/8 Fan failure.
E/9 Defect T sensor on inductor.
E/A Hardware defect of induction
modul.
E/C
Coniguration failure.
E/H
Fixed sensor value.
ER31/ER47
Control board.
ER 22 The control board switches off
after 3,5-7,5 seconds.
The control board switches off
ER 03/
after 10 seconds.
ER20 Error in the control board.
- -
ing level is
r e s t o r e d
to 0.
L
No error! All functions are
blocked.
Possible causes:
It's not an error, the user is in the
service menu.
The user is in the service menu,
it's not an error.
The user is in the service menu,
it's not an error.
Pot creates on the modul an im-
proper operating point which can
destroy devices, e.g IGBT' .
Induction modul is not con-
igured.
No power supply of induction
modul.
1. Failure in main power fre-
quency detection.
2. Over voltage.
Fan or control electronic is defect. Contact the technical Service.
Sensor signal out of valid range;
sensor or electronic is defect.
Defect hardware device detected
by the self check of the modul.
2 cooking zones are dedicated to
the same element of the UI.
-
Error in the control board.
Error in the control board.
Presence of liquids or pans on the
control area.
Memory error.
Failure on the induction module. Contact the after-sales service.
-
- 33 -
A suitably pan must be placed on the
relevant cooking zone.
Wait for the sysmbol "-" or abort the con-
iguration activities by pressing the select-
key and the "C" does not blink anymore.
Manual coniguration.
System must cool down.
1. The error is automaticly cancelled after
8s and the cooking zone can be used
again. In case of further upcoming errors
the pot have to be changed.
1. Delete the hob coniguration and acti-
vate the manual coniguration.
2. Start the UI service menu to conigure
the induction modul.
Contact the technical Service.
Contact the technical Service.
Contact the technical Service.
Contact the technical Service.
1. Erase the actual coniguration manual
coniguration with service menu.
System must cool down.
Contact the after-sales service.
Contact the after-sales service.
Clean the glass-ceramic surface.
Contact the after-sales service.
Deactivate the key function.