BaByliss PRO BAB831C Directives D'utilisation page 3

OPERATION
Before using the Class 2 Power Supply, read these instructions carefully.
This trimmer (BAB831C) uses with CA01M adaptor (included) only.
Input: 100-240 V AC 50/60Hz 0.2A Max
Output: 3.0V DC 1000mA
IMPORTANT NOTE:
1. Never operate this unit if the specification is out of the rating.
2. This unit may become warm during use. This is normal.
BAB501 Detachable
Fine Tooth
Cutting Blade
Comb Attachment
# T1 – 1/8" (3 mm)
Comb Attachment
Recharging Receptacle
# T2 – 1/4" (6 mm)
BAB831C IB-11_631C.indd 5-6
Lubricating Oil
Blade Guard
I-ON / 0-OFF
Switch
CA01M Outlet
Cleaning
Adaptor and Cord
Brush
Comb Attachment and
Blade Guard Holder
LED Indicator
Charging Base
OPERATING INSTRUCTIONS
1. Before using the appliance for the first time, charge continuously for 16
hours. Maximum battery capacity will only be reached after 3 charging and
discharging cycles.
2. Make sure the switch is in "0-OFF" position. Plug the charging jack into the
receptacle at the back of the charging base. Plug the adaptor into an electrical
outlet. The LED indicator will light up to indicate that charging has begun.
3. After recharging or use, store the appliance in a dry place and keep away from
children.
4. Do not wrap the cord around the appliance or the charging base.
5. Preserving the battery: In order to maintain the optimum capacity of rechargeable
battery, the appliance should be recharged for 16 hours approximately every 3
months.
6. Unplug the outlet adaptor after use.
7. This power unit is intended to be correctly oriented in a vertical or floor-mount
position.
8. CAN ICES-3 (B)
HOW TO CHARGE AND USE AS RECHARGEABLE UNIT
Plug the charging jack into the receptacle at the back of the charging base. Plug
the outlet adaptor into the power socket and place the trimmer into the charging
base. When the LED indicator lights up, the unit is charging. The switch should be in
"O-OFF" position when charging. After the unit is fully charged, remove it from the
charging base and switch to "l-ON" position to operate.
FOR DIRECT PLUG IN OPERATION
Make sure the switch on the trimmer is in "0-OFF" position. Plug charging jack into the
receptacle at the bottom of the unit and plug the outlet adaptor into the power socket.
Allow 2 to 3 minutes for the battery to kick over. Switch to "l-ON" position to operate.
1/28/15 2:27 PM