Safety Notes; Technical Data; Symbol Description; Installation Instructions - Hansgrohe Showerpipe Croma 220 Reno 27224000 Mode D'emploi / Instructions De Montage

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 3

Safety Notes

Gloves should be worn during installation to prevent crushing and cutting
injuries.
The arm of the shower head is intended only to hold the shower head. Do not
load it down with other objects!
Children as well as adults with physical, mental and/or sensoric impairments
must not use this product without proper supervision. Persons under the influ-
ence of alcohol or drugs are prohibited from using this product.
Do not allow the streams of the shower touch sensitive body parts (such as your
eyes). An adequate distance must be kept between the shower and you.
The product may not be used as a holding handle. A separate handle must be
installed.
The product may only be used for bathing, hygienic and body cleaning pur-
poses.
The hot and cold supplies must be of equal pressures.

Installation Instructions

• Prior to installation, inspect the product for transport damages. After it has been
installed, no transport or surface damage will be honoured.
• The pipes and the fixture must be installed, flushed and tested as per the applica-
ble standards.
• The plumbing codes applicable in the respective countries must be observed.
• The installation dimensions stated in these installation instructions are ideal for
people of approximately 1800 mm in body height. The dimensions can be
altered if required. In this case, pay attention to the fact that a change of instal-
lation height will also change the minimum height, and that the altered mounting
dimensions must be taken into consideration.
• During installation of the product by qualified trained personnel, make sure that
the entire fastening surface is even and smooth (no protruding seams or tile
offset), that the finish of the wall is suitable to apply the product and has no weak
points.
• The premounted filter insert must be used to ensure a normal flow of the shower
and to prevent dirt from entering through the pipes. Dirt entering can affect the
function and/or lead to damages to the shower. Hansgrohe will not be held
liable for this type of damage.
• The shower may only be connected downstream of a shut-off valve or sanitary
fitting.
• If required, the bottom part of the pipe between the fixture and the shower head
can be shortened with a fine-toothed saw.
4
English
All manuals and user guides at all-guides.com

Technical Data

Operating pressure:
Recommended operating pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Thermal disinfection:
• Safety against backflow
• The product is exclusively designed for drinking water!

Symbol description

Assembly see page 31
Do not use silicone containing acetic acid!
Operation (see page 33)
To empty the overhead shower after use, hold it in a slightly inclined
position.
Maintenance (see page 33)
The check valves must be checked regularly according to DIN EN
1717 in accordance with national or regional regulations (at least once
a year).
Cleaning (see page 34)
Dimensions (see page 36)
Flow diagram (see page 36)
Hand shower
overhead shower
Hand shower + overhead shower
Spare parts (see page 37)
Special accessories (order as an extra)
tile-matching-disk chrome plated #98681000
Test certificate (see page 40)
max. 1 MPa
0,17 - 0,5 MPa
max. 60°C
max. 70°C / 4 min

Publicité

Table des Matières
loading

Table des Matières