Velleman VASH2 Notice D'emploi page 3

Connection
5.
• Connect the HDMI cables from the HD sources (PS3, DVD player) to the input ports (6) of
the HDMI Switcher.
• Connect the HDMI cable from your HD display (monitor or projector) to the output port (5)
of the HDMI Switcher
• Plug the 5VDC power supply connector in the HDMI Switcher DC input (4) and plug the
adaptor in the mains.
• [only for VASH2] The (red) power indication LED (2) on the front panel will flash. This
means that the HDMI switch is searching for inputs. Once inputs are detected, the LED (2)
will turn steady on.
• The latest selected input port is memorized and will be detected and connected first at next
start-up.
• The selected input port is indicated with a (green) LED (3) on the front panel.
6. Operation
Auto detection operation mode (only for VASH2)
•
At start-up, the HDMS switcher will sequentially scan all inputs (loop starting at 1) until a
valid input is detected.
•
Simply turn on the preferred HDMI device and the switcher will find it.
Manual operation mode
•
To turn the switcher on, press the on/off & select switch (1).
•
Use the on/off & select switch (1) on the front panel to cycle through the channels until the
preferred HDMI device is found.
•
To turn the switcher off, press and hold the on/off & select switch (1) for 3 seconds.
IR remote operation mode
•
Use the IR remote to power the HDMI switcher on or off.
•
Use the numbered buttons on the remote control to toggle between inputs, or use the
forward and back button.
Note: when a HDMI device is powered on, the switcher will automatically select the input of
that device (only VASH2).
00 (02/09/2008)
All manuals and user guides at all-guides.com
VASH2 & VASH3
3
VASH3
A - FRONT
1. on/off & select switch
2. power LED (red)
3. input LEDs 1~2 (green)
B - BACK
4. DC input
5. HDMI output
6. HDMI input 1~2
VASH2
A - FRONT
1. on/off & select switch
2. power LED (red)
3. input LEDs 1~4 (green)
B - BACK
4. DC input
5. HDMI output
6. HDMI input 1~4