Aleratec 350123 Guide De Démarrage Rapide page 5

Using the HDD Copy Dock
Duplicating Hard Drives
1. Use the included power adapter and cord to plug the HDD Copy Dock into a power
outlet.
2. Insert the SATA Hard Drive you want to copy into the slot marked "SOURCE".
When inserting, align the SATA port on the Hard Drive with the SATA connector in
the drive bay slot.
3. Insert the destination SATA Hard Drive into the slot marked "TARGET". When
inserting, align the SATA port on the Hard Drive with the SATA connector in the
drive bay slot.
Note: Make sure the target Hard Drive has the same or higher capacity than
your source Hard Drive. The duplication process will not start if the target
drive has a lower capacity. Also make sure the unit is not connected to a PC
through the USB port.
4. Power on the HDD Copy Dock.
5. Press and hold the MODE button for 3 seconds to change the duplicators Mode to
Copy Mode.
6. Press and hold the Copy button for 5 seconds. The unit will emit a long beep.
Release the button as soon as you hear the beep. The first status bar indicator light
will begin flashing when the clone process starts.
Note: Starting the copy process will also erase all data on the target drive.
7. The duplication process is complete when the status bar reaches 100% and stops
blinking.
8. Power off the HDD Copy Dock to remove the hard drives.
www.aleratec.com 3